sink mark

常见例句

雙語例句

• Too high switch point: empty part, weld line, sink mark, and small.
  轉壓點太高：産品充模不足，熔接痕，凹陷，尺寸偏小等。
• How much pressure? thicker section is it possible to occur sink mark ?
  壓力有多大？ 厚的區域是否有可能出現縮水的現象？
• The generation processes of several typical injection molding defects, such as jetting and snake flow , sink mark and bubble, were directly observed and recorded.
  觀察竝記錄了典型成型缺陷産生過程，包括噴射與蛇形流動、縮痕、氣泡等，提出了解決這些成型缺陷的方法。2。

權威例句

• The spit sink left a permanent mark on the floor.
  FORBES: A Place of Excellence
返回 sink mark